ProtoThrottle Receivers

The ProtoThrottle Interfaces to any DCC system with a separate receiver.  This receiver converts the wireless signal from the ProtoThrottle into the specific protocol required by each unique command station.  Support for various command stations is shown in the table below.

Brand
Model
Receiver
Protocol
NCE
Power Pro
MRBW-CABBUS
Cab Bus
NCE
Power Cab
MRBW-CABBUS
Cab Bus
LenzLZV100MRBW-CABBUS
XpressNet
ESUCabControl
ESU-BRIDGE
ESU Proprietary
ESUECoS
ESU-BRIDGE - must connect through an existing wireless network
ESU Proprietary
DigikeijsDR5000MRBW-CABBUS
XpressNet
DigitraxAnyESU-BRIDGE - also requires LNWI module*
LNWI
MRCProdigyESU-BRIDGE - also requires Prodigy WiFi module*
WiThrottle
CVPEasyDCCESU-BRIDGE with JMRI (Example from The Hills Line)WiThrottle
Other

If it's compatible with JMRI, you can interface to it by running JMRI (requires computer running JMRI and appropriate interface to your DCC system) and connecting via the WiThrottle receiver interface.  JMRI hardware support can be checked here.
WiThrottle

*Note: If you already have a working JMRI installation with WiThrottle server, then the LMWI (Digitrax) or Prodigy WiFi (MRC) module is not required.  In that case, connect the ESU-BRIDGE to the WiThrottle server using the same settings you would use to connect a cell phone throttle.


ProtoThrottle Receiver for NCE Cab Bus and Lenz XpressNet

ProtoThrottle Receiver for NCE Cab Bus and Lenz XpressNet

This receiver connects the ProtoThrottle to an NCE command station or Power Cab* using the Cab Bus p..

$99.00

ProtoThrottle Receiver for ESU CabControl, JMRI WiFi Throttle, and Digitrax LNWI

ProtoThrottle Receiver for ESU CabControl, JMRI WiFi Throttle, and Digitrax LNWI

This receiver connects the ProtoThrottle to an ESU CabControl system,  JMRI WiFi Throttle ..

$99.00

XBee to USB Interface

XBee to USB Interface

This board is an interface between an XBee module and an FT231XS USB UART.  Originally des..

$20.00

Showing 1 to 3 of 3 (1 Pages)