Using MRGui on Mac OSX

MRGui is our configuration utility for MRBus based devices.  It simplifies the process of setting the various EEPROM configuration options for each node, using a user-friendly GUI that runs on Windows, Mac, or Linux.  In addition to setting EEPROM configuration options, MRGui can also be used for general purpose programming of AVR microcontrollers.  The instructions below take you through the steps to get up and running with MRGui on the Mac OSX platform.

Step 1 – Obtain a Programmer

Before configuring or reprogramming the firmware in an MRBus device, an AVR programmer is required.  Some products come standard with a programmer.  The USBtinyISP is our recommended programmer, because of its low cost and ease of use.  Compatible versions can be found here and here.  For advanced users, support for other programmers can be added on request.

Step 2 – Download MRGui

The latest MRGui release can be found on GitHub.  For OSX, download the latest mrgui-osx.dmg release.  Once downloaded, open the DMG disk image file.  The MRGui application icon should appear.  Double clicking the icon should start the application, but you may get a warning about the application being from an unidentified developer.

unidentified_developer

To get around this, right-click the MRGui icon and select Open.

right_click_open

The same dialog window will again appear, but this time with an Open button.  Click the Open button and the MRGui application should start.

At this point you are ready to use MRGui to configure your device!


FAQ

Q: What do I do if I get a “Could not find USBtiny device” error message when reading from or writing to a device?

could_not_find_usbtiny_device

A: First, check that the programmer is plugged into the computer’s USB port.  If so, try unplugging and re-plugging the programmer.  If none of these resolve the problem, then contact us, including as much information as possible.

Leave a Reply

Your email address will not be published. Required fields are marked *